Hello guys, I have a problem with DP8035, I changed the fuser lamp single and put it error code E04 01, and I dont have handbook to solve it.
-
-
Re: E04 01
This Service Handbook can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com -
Re: E04 01
The E4-01 is the fuser not coming up to temp.Verify all of the connectors. Sometimes they can fool you. They feel connected but in reality, are not. Ohm out the lamp you installed to verify it is good. If so, you also have a thermostat and thermal fuse that could blow. Go ahead and ohm those out. If everything checks out, you probably have a blown thermistor. After that, go for the AC Driver board the big fuser connector plugs into. Good Luck but E4-01's are usually pretty easy.Comment
-
Re: E04 01
Before you do anything, go into F9 service mode and run LBP Fuser Reset. That will get rid of the code in most situations.
Failing to plan is planning to fail!!!Comment
-
Re: E04 01
Ah. Totally over trouble shot. What Mojo said.Comment
-
Re: E04 01
We had an 8035 where the E4-01 kept returning, replacing the SPC board finally repaired it. Of course that's after running the LBP fuser reset.Comment
Comment