1035 ADF Registration ajustment?

[mkopoiuy]

Afcio 1035.
On the glass copy coming out OK.
But if i use ADF copy coming out leading edge and side to side registration is not OK.
Could anyone help how to adjust of registration by using ADF!
thanks

[Ricoh-ono]

I believe you can adjust that in the SP mode 6-xxx range.

[mkopoiuy]

I believe you can adjust that in the SP mode 6-xxx range.

thank you very much.
i made 6-xxx -30 is maximum.
still 3mm off of side to side registration.
any more adjustment is there?

[Ricoh-ono]

If you are -33mm off, I would revisit the paper trays to make sure the paper guides have not jumped track.

[schooltech]

Aren't there also slotted adjustment screws on the ADF mounting brackets? I can't remember if these have them or not. They may help just a bit if there is.

But, the rear guide may have jumped a tooth and it's off a bit.

I've always thought it was a bit weird to have those adjustments in the 6-xxx area. It seems just so out-of-place.

I think Ricoh-ono is right with that one-recheck the drawer.

[nmfaxman]

Paper in drawers up to and touching paper.
Right hinge skew adjustment is covered by black mylar.
Also check the scan glass is installed correctly and tacked down.
6XX code is for periferals, where else should it be.
Under drum adjustments?

[schooltech]

Maybe put under the 1-xxx with the rest of the reg. and buckle adjustments.

I know they are there at the 6-xxx for peripherals, but noob techs can get frustrated when they aren't familiar with the locations of certain adjustments.

Also, what about the 1-902 on a 1075 for clearing the web, or in the 2-xxx for clearing the suction motor counter on a 2105? Just weird spots to throw counters to have to clear, like the normal 7-xxx for counter-clearing.

As an experienced Ricoh tech, I know where to look. Just an observation, that's all. No worries nmfaxman We're all playing in the same game.