af 2022

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Gab
    Senior Tech
    • Aug 2015
    • 671

    #1

    af 2022

    Press roller remeves from it's position and the two rollers doesn't press each other. I put it in right position but after few copies it removes from proper position again. The side that the gap between 2 rollers appear is that at the green lever. The green lever is ok and not broken. Any idea?
  • TonerMunkeh
    Professional Moron

    2,500+ Posts
    • Apr 2008
    • 3865

    #2
    Re: af 2022

    Fusing frame broken or pressure roller bearings siezed perhaps?
    It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.

    Hit it.

    Comment

    • laitang
      Senior Tech

      500+ Posts
      • Nov 2012
      • 627

      #3
      Re: af 2022

      Replace pressure roller and it's bearings

      Comment

      • slimslob
        Retired

        Site Contributor
        25,000+ Posts
        • May 2013
        • 37489

        #4
        Re: af 2022

        Plastic lower frame broken where the cleaning roller mounts. Replace the fusing unit.

        Comment

        • copyaction
          Senior Tech

          Site Contributor
          500+ Posts
          • Oct 2007
          • 991

          #5
          Re: af 2022

          Someone in an older post had suggested using the type of press roller bearings with the groove around the outer edge that supposed to keep them in place.
          innthe past I have had to end up replacing the fuser.

          Comment

          • Polarbear
            Service Manager

            1,000+ Posts
            • Feb 2012
            • 1070

            #6
            Re: af 2022

            Originally posted by slimslob
            Plastic lower frame broken where the cleaning roller mounts. Replace the fusing unit.
            Agreed.

            If the HOT ROLLER is moving, it is caused by plastic guides in the lower frame - to the inside of the metal brackets that the bearings fit into.
            They break - normally the on left side (furthest from the drive gear) and then the hotroller moves in the direction of the drive gear until the bearings slip out of their guides and this movement causes the loss of pressure between the hot roller and pressure roller.

            The pressure roller is held in place by metal prongs on the metal risers either side of it. On the one side (normally same side as the hot rolelr drive gear) of the pressure roller is a spring that holds the bearing in place. Is it installed correctly? (see attached photo with red arrow pointing towards the spring).

            hotroller.jpg
            Press the GREEN button!!

            Comment

            • Mark Bbb
              Service Manager

              1,000+ Posts
              • Jun 2012
              • 1662

              #7
              Re: af 2022

              The ball bearing holder on the fusing frame is broken at the rear side, so:
              bent the rear of the metal frame of the stripper finger bar thus fixing the rear hot roller ball bearing...
              So, save costs...
              OK?

              Comment

              • HitMan
                Trusted Tech

                100+ Posts
                • Aug 2015
                • 170

                #8
                Yeah I've done that a few times. Not much point spending money on a device that old. Just make sure there's no movement on the rollers when they are all tensioned up.
                That's what the newer version of those machines have 2 metal bearing stoppers coming down from the fuser pawl plate

                Comment

                Working...