Re: Ricoh mpc 5000
The pressure roller thermostats have jumped. Reset or replace them.
Ricoh mpc 5000
Collapse
X
-
Re: Ricoh mpc 5000
Assuming the thermistors are in place properly and the code was reset after with SP 5-810; Check that you didn't pinch a wire, then check the Thermostats, then check the lamp.
If you can't get continuity on the Thermostats with a Voltmeter then one popped. You can 'reset' them but they are cheap enough to just throw in a new one.
Then check that the lamp is in the proper temp range (SP1-10x?) assuming the code doesn't pop instantly on power up.Leave a comment:
-
Ricoh mpc 5000
I have this problem sc565 I change thermistor and same problem anyideas
Sent from my SM-J105B using TapatalkTags: None
Leave a comment: