03 Internal finisher sr-3130

[ABS tect]

[Zeldaman]

[fshead]

Re: 03 Internal finisher sr-3130

i had one come back from lease where it must have been in a dirty warehouse.
It would jam/stop lead edge 3 inches above fuser unit.
And then it would code out "i think" sc 724-70.
I ENDED up taking it out 1st and machine ran ok so pulled all covers off the mini sorter,blew out all sensors and then
wiped out all areas wth a windex paper towel and then lightly sprayed windex on all sensors as i hit them wth air..
It worked for me..

[fshead]

Re: 03 Internal finisher sr-3130

I just found posts

http://www.copytechnet.com/forums/ricoh-savin-gestetner-lanier/132439-mpc3003-sc-724-70-a.html#post697184

[Polarbear]

Re: 03 Internal finisher sr-3130

Hi.

Had something similar recently. Seems that someone managed to get the 2x black arched paper stoppers (that normally sit on top of the paper table) underneath it, so that the paper table could not move at all. I discovered this when i tried to move the table by hand, and also once i opened the mech that lifts/lowers the table and manually dropped the actuator and the table still did not want to move.

Once the stoppers were in the right place all was well again.

[Like1mS]

Re: 03 Internal finisher sr-3130

Hi.

Had something similar recently. Seems that someone managed to get the 2x black arched paper stoppers (that normally sit on top of the paper table) underneath it, so that the paper table could not move at all. I discovered this when i tried to move the table by hand, and also once i opened the mech that lifts/lowers the table and manually dropped the actuator and the table still did not want to move.

Once the stoppers were in the right place all was well again.

Just wanted to say thanks, because your answer saved me today I picked apart the whole thing looking for a problem, and it turned out to be this.....
Popping the arms back on top of the tray indeed sorted it out.

[TonerMunkeh]

Re: 03 Internal finisher sr-3130

Just wanted to say thanks, because your answer saved me today I picked apart the whole thing looking for a problem, and it turned out to be this.....
Popping the arms back on top of the tray indeed sorted it out.

Wait till you get that assembly broken into 3 pieces and have to figure out how to put it back together again, with all the springs, bushings and feelers

[Like1mS]

Re: 03 Internal finisher sr-3130

Wait till you get that assembly broken into 3 pieces and have to figure out how to put it back together again, with all the springs, bushings and feelers

Been there, done that, after that finisher went to recycling company . Lesson learned, always mark take photos for reassembling later. Luckily this time it was enough to dissasemble half of it.
If i had stumbled on this post earlier, and not going by the ricoh remedy list, would not have had to dismantle it this much at all.

[fshead]

Re: 03 Internal finisher sr-3130

I had that occur on a tested mpc3503 wrapped and somehow when it got to my account both stoppers had moved under tray..very odd.
So after pulling unit covers and fixing it all was good.
On any other internal finishers that i deliver i always tape a piece of cardboard between stoppers and tray before shrink wrapping..