mpc6004ex only one impression

[Phil B.]

Re: mpc6004ex only one impression

its oem as far as i can tell, i ordered oem sleeve and lower roller always replace these together,
toner is oem, i just can see failure at 60k-70k impressions,,, but who knows..

never skimp on fuser rebuilds... bearing seize.. thermostats and thermistors go bad... I ALWAYS do a complete rebuild.

[digicor]

Re: mpc6004ex only one impression

update on double imaging
the toner was some crap aftermarket toner, dont know who put that in or how it got in the machine, i suspect someone swapped out a oem for a compatable...
i switched out ran about 300 copies, first few had slight shadow but then it went away, the fuser is popping a bit after the copies have been generated is there a setting for this? rotation after the job?
, i suspect someone took the NEW fuser with 40k on it and put a used fuser in it at the warehouse where i bought the machine
this is common among thieves and copier guys...
thanks for the help