mp5055 bad quaity

[Marwanalhajbi]

the counter is 2500 only,i have changed pcu,trnasfer roller,fusing unit,and clean the glass of lazer unit,please check the outputWhatsApp Image 2021-07-13 at 3.28.12 PM.jpg

https://we.tl/t-mzTiNmvgj5

ps: portrait and landscape same rsult.

thanks alot

[davel]

Re: mp5055 bad quaity

Toner saver?

[FrohnB]

Re: mp5055 bad quaity

Uh Oh! Looks like someone may have forgotten or didn't know how to do the initial set up for this series.

When you first turn it on, you MUST have the front door open, otherwise the machine starts a "normal toner supply" which doesn't fill the development unit properly.

-When the machine is Very first started, you want the front cover open,
-then you enter SP mode and go to SP 3-510-031 and set that to "1".
-Exit out of SP mode, and THEN close the front cover. Machine starts initializing.
-Once that's finished, you need to get back into SP mode, and go to SP 3-011-001 (Manual ProCon), and press "Execute".
-Exit out of SP mode.


Note if the initial toner supply has not been performed.
If you start printing without executing the initial toner supply at installation, the machine goes to the toner end condition even if the machine has plenty of toner in the toner bottle.
Do the following procedure to perform the toner end recovery if the machine has entered the toner end condition.
1.Open the front cover for five seconds or more.
2.Make sure that the toner bottle is set properly.
3.Close the front cover.
4.The toner end recovery automatically starts

[MIKON]

Re: mp5055 bad quaity

Check image on drum.
I have seen the front pivot point for the transfer roller get knocked out of position causing poor transfer on the front side.

[mga]

Re: mp5055 bad quaity

Check image on drum.
I have seen the front pivot point for the transfer roller get knocked out of position causing poor transfer on the front side.

+1

[Ricoh-ono]

Re: mp5055 bad quaity

Check image on drum.
I have seen the front pivot point for the transfer roller get knocked out of position causing poor transfer on the front side.

Had this happen on an MP 3055 today. Both sides of the pivot point were stuck in the down position.