SC692 on an MP161LN

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • wwaweru
    Technician
    • Aug 2009
    • 25
    #1

    SC692 on an MP161LN

    Hi Folks,

    I need some with an MP161LN that fires an SC692 whenever i try to input an IP Address, i have already changed the printer board, but am still getting the same error any assistance will be greatly appreciated.


    Regards,
    waweru
    Tags: 141, 415, address, appreciated, assistance, between, cables, check, codes, connections, error, etc, input, ip address, issue, laser, manual, mp161ln, nec, printer, printer board
    • TonerMunkeh
      Professional Moron

      2,500+ Posts
      • Apr 2008
      • 3865
      #2
      Manual suggests BICU board and harnesses / ribbon cables etc between.
      It's 106 miles to Chicago. We've got a full tank of gas, half a pack of cigarettes, it's dark and we're wearing sunglasses.

      Hit it.

        Comment

        • wwaweru
          Technician
          • Aug 2009
          • 25
          #3
          SC692 on an MP161LN

          Originally posted by TonerMunkeh
          Manual suggests BICU board and harnesses / ribbon cables etc between.
          Hi TonerMukeh,

          Thanks for the reply, i have checked all the harnesses and believe they are ok and fitted correctly I was hoping it would not be the BICU board, i guess ill have to get another one and see if it sorts out my issue, thanks again.

          Waweru.

            Comment

            • Jomama46
              Field Supervisor

              Site Contributor
              2,500+ Posts
              • Apr 2008
              • 2900
              #4
              Da Goose says " GAVD bus error - check for hidden laser codes, check laser connections to BICU"
              sigpic
              You never realize how cheap a professional is until after you let an amateur do it.
              A+; Network +; PDI+

                Comment

                Previous template Next
                Working...