[Jamming] SR3020 on MCP4000 with staple exit jam Code 195

[TCA TECH]

Hi All,
I have an issue with a SR3020 on MCP4000 with staple exit jam Code 195

I have updated firmware, replaced exit sensor, Exit gate lift motor, exit gate feed motor, controller PCB, tray sensors.
195 code states exit sensor not detewcting paper as feeds out. test in iput mode ok. work fine in proof and booklet mode and no staples.

help

[TCA TECH]

Re: SR3020 on MCP4000 with staple exit jam Code 195

reposted in copier section

[TCA TECH]

Re: SR3020 on MCP4000 with staple exit jam Code 195

Problem caused by binding on the foam rollers and idlers to the belt on exit. This just put too much load on moter that stopped with the slightest amout of extra resistance. Only found after I replaced everything else

Intermittent with thicker staple jobs worse.