MP W2400 cutter problem

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • cbr600
    Technician

    50+ Posts
    • Jun 2010
    • 71

    #1

    MP W2400 cutter problem

    Got a wide format machine with a feed problem like: the cutter is not going all the way to left and it stucks almoust to the left end, and the paper when is feed it got jam becouse of it.The jam is random and a screatching noise is hearing.
    The gears and the motor from cutter are ok nothing is stuck there.
    Any other ideeas what this could be ? Thx
  • Polo-022
    Trusted Tech

    250+ Posts
    • Sep 2007
    • 486

    #2
    Re: MP W2400 cutter problem

    Don't spent your time here...
    open your toolcase, your service manual , take your favorite screw-driver,
    bent your knees and follow the procedure to find out : what is down under the cutter
    that blocks paper path...

    Comment

    • cbr600
      Technician

      50+ Posts
      • Jun 2010
      • 71

      #3
      Re: MP W2400 cutter problem

      I will tomorrow but i was thinking someone know about this problem and go directly to it.

      Comment

      • JustManuals
        Field Supervisor

        5,000+ Posts
        • Jan 2006
        • 9838

        #4
        Re: MP W2400 cutter problem

        This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


        Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


        Paul@justmanuals.com

        Comment

        • jdzr
          Trusted Tech

          100+ Posts
          • Jan 2010
          • 125

          #5
          Re: MP W2400 cutter problem

          Cutter on this machine is so simple one good look should tell you what is happening. Run the knife in diagonostics and watch it work. Most problems are caused by small slivers of paper getting into the knife drive gears or cable problems.

          Comment

          • rsyarcia
            Hair Straightener Tech

            500+ Posts
            • Feb 2008
            • 711

            #6
            Re: MP W2400 cutter problem

            faced this problem before and it was the feed clutches on the feed roller tray. try to interchange the clutches from paper roll 1 to roll 2.
            Nobody is perfect..

            Comment

            • cbr600
              Technician

              50+ Posts
              • Jun 2010
              • 71

              #7
              Re: MP W2400 cutter problem

              I clean everything in cutter section, i push out a bit the left switch, and yes i was thinking about the clutch.Since today no jams, i will see in next days.Thx for ur ideeas.

              Comment

              Working...