Stupid question today,
Symptoms:
1. Ran single side with a Finisher SR3020 staple or without staple fine but when ran duplex it will fold on the top right corner of the paper (8 out of 12 pages in a stack).
2. If I ran duplex in smc mode direct paper into the internal tray, there is no dog earring/creasing.
So far, I've replace the duplex guide and lower fuser temp by -10c. It still the same. What cause this problem. Any suggestions are appreciated.
Symptoms:
1. Ran single side with a Finisher SR3020 staple or without staple fine but when ran duplex it will fold on the top right corner of the paper (8 out of 12 pages in a stack).
2. If I ran duplex in smc mode direct paper into the internal tray, there is no dog earring/creasing.
So far, I've replace the duplex guide and lower fuser temp by -10c. It still the same. What cause this problem. Any suggestions are appreciated.