Ricoh 1045/ Sc 672????

[paulg]

As well as firmware you have checked the connections between the controller and the keyboard/op pannel? It has been known for the cable between scanner unit and controller to get dammaged or twist.

Sometimes better to check the simple fixs before swapping the whole board over.

[Jomama46]

As IMIND says, there is new firmware to correct this, try that before replaceing the controller.

Thank you friends, excuse that it bothers a lot.
Today I face to this it schemes, later I count them that it happened.

[Ricoh-ono]

Well, it looks like you will have to replace the controller.hehehe

Thank you for your suggestion, but the HD already disconnect and SC 672 persists, doesn't walk

[iMind]

you believe that rebot the hard disk press (*) + (#) + power on ????

Mr. nickname said, unplug the hard disk, this means desconnect the drive. there is a new firmware for that SC. turning off and back on this service call is normally cancelled.

you believe that rebot the hard disk press (*) + (#) + power on ????

[Ricoh-ono]

try unplugging the harddrive and reboot. If it still comes up with a 672 then your controller is probably f*cked.

[copiadoratecnicad]

helps, like I unblock code SC672

with this message in screen cannot make Adj.