MPC 2800 duplex-jam J025

[Zeldaman]

Hi there!
Had a very nice problem. Allways J025 when duplexing, paper allways and exactly at this position20130909_150050.jpg

[afat]

Re: MPC 2800 duplex-jam J025

Hi there!
Had a very nice problem. Allways J025 when duplexing, paper allways and exactly at this position[ATTACH=CONFIG]22020[/ATTACH]

I also had this problem, i try change the motor also not working....have another solution?

[davel]

[afat]

Re: MPC 2800 duplex-jam J025

Okay thanks you sir, i try first

[GIUBOSS]

Re: MPC 2800 duplex-jam J025

D0294492 Fusing Entrance Guide Plate, if it's old, replace it

[GIUBOSS]

Re: MPC 2800 duplex-jam J025

if it's old, replace it: D0294492 Fusing Entrance Guide Plate

[sandmanmac]

Re: MPC 2800 duplex-jam J025

The initial post is most likely a different problem than yours. The cause of duplex jams in these units is pretty common in my experience, and is almost always due to gate being warped from the heat of the fuser.
Duplex.jpg

[skinnyb]

Re: MPC 2800 duplex-jam J025

The initial post is most likely a different problem than yours. The cause of duplex jams in these units is pretty common in my experience, and is almost always due to gate being warped from the heat of the fuser.
[ATTACH=CONFIG]44053[/ATTACH]

Agreed. I have replaced several over the years. The old ones warped easy. They redesigned the part and put a metal shaft in the center for support. Those work much better.

Sent from my LM-V405 using Tapatalk

[skinnyb]

Re: MPC 2800 duplex-jam J025

The initial post is most likely a different problem than yours. The cause of duplex jams in these units is pretty common in my experience, and is almost always due to gate being warped from the heat of the fuser.
[ATTACH=CONFIG]44053[/ATTACH]

Agreed. I have replaced several over the years. The old ones warped easy. They redesigned the part and put a metal shaft in the center for support. Those work much better.

Sent from my LM-V405 using Tapatalk

[Oze]

Re: MPC 2800 duplex-jam J025

D0294492 Fusing Entrance Guide Plate, if it's old, replace it

Like this post you mean?

[Zaxxon]

[usta]

Re: MPC 2800 duplex-jam J025

replace the roller gears for turning the belts at the edges of the duplex.

[usta]

Re: MPC 2800 duplex-jam J025

b223 4529
b223 4514
b223 4535