If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
MPC 6003 FAX forward to PDF (don“t work just get TIFF)
Ricoh actually tried to make FAX forwarding setup easier. You no longer have to use parameter switches to turn off printing memory transfer files and transfer file type. Under User tools - Fax - Reception tab - Reception settings. You will have three options:
Forwarding. Turn On and Off, select destination, and a couple of other options
Print. Turn On and Off
File type. Select TIFF of PDF
The bit switch settings in Parameters do not work.
Have try all this did not found the file type under reciption settings, but under initial settings... it was set on pdf.. but still get tiff. I have also looked under all options in WIM and the only pdf option i found was send to folder pdf on/off.....
did not found the file type under reciption settings, but under initial settings... it was set on pdf.. but still get tiff. I have also looked under all options in WIM and the only pdf option i found was send to folder pdf on/off.....
Comment