Gestetner 3235e says cover door open and wrench light is on. How do I turn off wrench. Cover door is closed and door sensor seems to be working. It also has error code SC320
-
Last edited by Guest; 06-04-2008, 08:01 PM. -
Your error code has to do with the polygon motor in the laser unit. You can try to reset it by pressing "clear modes", 1, 0, 7, hold down the stop button for 3 sec. Enter the copy mode simulation then turn your machine off and on. If it doesn't reset then you have an issue with your laser unit!
Good luck! -
Unplug the machine and plug it back in.
If that doesn't work your polygon motor is locked up.
Call a tech.Why do they call it common sense?
If it were common, wouldn't everyone have it?Comment
-
Yep, needs a PM motor. That close door can be any of a dozen of those little push switches. Most can be eliminated by using the input checks tho.
sigpic
You never realize how cheap a professional is until after you let an amateur do it.
A+; Network +; PDI+Comment
-
Thanks this information helped a lot.Comment
Comment