MP6500 THERMISTER

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • Herostrat
    Trusted Tech

    100+ Posts
    • Oct 2012
    • 220
    #16
    Re: MP6500 THERMISTER

    Slimslob you might be right,guy operating MP6500 used to be tech back in analog days,and his IT colegues aren't shy to look up the solution on that cursed Fixya...
    Gears,springs,clutches,sliders,connectors and electronics...who on earth can tell what's wrong with it?

      Comment

      • slimslob
        Retired

        Site Contributor
        25,000+ Posts
        • May 2013
        • 37490
        #17
        Re: MP6500 THERMISTER

        Originally posted by fshead
        as i sit enjoying a fine glass of wine i thank you.
        i never thought the heater lamps had any other purpose but heat up the roller in a determined time>>>>wrong.
        i did try cheating warm up by opening n closing fnt door>>no good
        yes there is a lamp for just the ends...as it turns out the bottom blue connector lamp 550w went out.
        wth meter in hand n some friday kharhma....my happy law firm was back in biz adding to the world
        more useless piles of paper and things to be read..
        Originally posted by Herostrat
        Slimslob you might be right,guy operating MP6500 used to be tech back in analog days,and his IT colegues aren't shy to look up the solution on that cursed Fixya...
        The 20 degree difference between the center and the end temperature was the give away.

          Comment

          Previous 1 2 template Next
          Working...