NOTICE: Users should expect a few periods of downtime this weekend while we work on a few updates to the system.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Probably more likely its not connected to the network either the cable is broken or it just isn't plugged in the Orange light is always on the green one doesn't come on if its not connected
This machine is on a ship and I can only get to it when the ship is in port. The problem is the orange light stays on, and when they send a print it does nothing. My guess is that the network controller does not work. Am not sure how to clear this in sp mode.
mfd network interface is faulty and flashin red led light (with or without network cable) tried remotely but no access to access codes to change the settings.
There is no red light on the network interface. There's orange and/or green.
If you're talking about the tiny little red led you can see inside - it always flashes red
So how about being a little more specific as to what you are actually talking about???
And what 'access codes' ?
Side note: Why the tinyfont.Are you shy or something?
Are you referring to the red light next to the Printer Function button on the control panel or the one next to the network connector? If it is the one next to the network connector, clear the following:
A red light on the printer button could be the application you are printing from needs a size of paper that is not in the machine. The print job will be at least partially stored in the machine's memory, which is why the red light appears whether the network cable is plugged in or not.
You should check that.
And what have you tried so far? Are you sure it is faulty and you haven't just not setup the interface settings correctly? If you think it is faulty then you should replace the controller.
mfd network interface is faulty and flashin red led light (with or without network cable) tried remotely but no access to access codes to change the settings.
Leave a comment: