SPC430DN SC452

[sandmanmac]

Re: SPC430DN SC452

I must admit, I overlooked your inclusion of SC400.

You've only cleaned the ID sensor, but it may need replacement, otherwise likely the BCU.

[GeorgeBest]

Also? So at some point you weren't aware then...because it was never going to be a belt issue.

So then, it's either the contact sensor or the motor.

[sandmanmac]

Re: SPC430DN SC452

I understand . .
swapped the roller also.

Also? So at some point you weren't aware then...because it was never going to be a belt issue.

So then, it's either the contact sensor or the motor.

[GeorgeBest]

Re: SPC430DN SC452

I understand . .
swapped the roller also.

Let's be clear.....You understand that this is a transfer roller error, and not a transfer belt error ??

[sandmanmac]

Re: SPC430DN SC452

Hi,

swapped the entire transfer unit . . .

Let's be clear.....You understand that this is a transfer roller error, and not a transfer belt error ??

[GeorgeBest]

Hi,

Error SC452 is returning on this machine. (Also SC400 sometimes)
Checked sensors, cleaned the ID sensors, swapped the entire transfer unit . . .
Sometimes the machine works fine, but for only a small period.

some one a clue here ?
Just a couple of machines in the field.

Thanks in advance