Wierd Issue with MX-M623
OK Guys,
I had a call for buzzing noise on a 623. turned out the Surge suppressor was buzzing but still functioning.
I replaced the surge suppressor & was good to go. About a week later I got a call that machine was dead & wouldn't come on.
Took a power supply both AC & DC from another machine along with a control panel machine wouldn't boot up and there was only the control panel led light on. Replaced power supplies and control panel no power on DC PS fuses but had AC to boards. But machine still wont power up.
Brought it into shop put parts from customers machine back into parts machine & Parts machine came on and ran. Turned on customers machine in our shop and it booted up and ran for 5 days. Took machine back to customer it booted up and printed 3 total sheets for me then died when I opened adf to make some copies. It wouldn't come on after that. Brought back to shop plugged in and it came on and has been running all day. I moved a 503 into the spot 623 was located in and it ran fine for all 5 days using the same surge suppressor. Only variable is Customer has a finisher but we used one of ours and it is not having an issue. I have checked connections and shook the hell out of it while running still running . Any thoughts are appreciated.
I had a call for buzzing noise on a 623. turned out the Surge suppressor was buzzing but still functioning.
I replaced the surge suppressor & was good to go. About a week later I got a call that machine was dead & wouldn't come on.
Took a power supply both AC & DC from another machine along with a control panel machine wouldn't boot up and there was only the control panel led light on. Replaced power supplies and control panel no power on DC PS fuses but had AC to boards. But machine still wont power up.
Brought it into shop put parts from customers machine back into parts machine & Parts machine came on and ran. Turned on customers machine in our shop and it booted up and ran for 5 days. Took machine back to customer it booted up and printed 3 total sheets for me then died when I opened adf to make some copies. It wouldn't come on after that. Brought back to shop plugged in and it came on and has been running all day. I moved a 503 into the spot 623 was located in and it ran fine for all 5 days using the same surge suppressor. Only variable is Customer has a finisher but we used one of ours and it is not having an issue. I have checked connections and shook the hell out of it while running still running . Any thoughts are appreciated.
Comment