Sharp mx-m264

[davebtech]

[moose55]

Re: Sharp mx-m264

Check connectors for the delivery unit, or swap it with another delivery unit. Trouble more than likely lies in that unit.

[Ratchet2501]

Re: Sharp mx-m264

Last one of these I had was the plastic tab attached to the exit sensor kept falling off. But it looks like you already checked that route.

[Luke123]

Re: Sharp mx-m264

Did you do sim 30-1 before just ordering sensors. That may lead you to the sensor. It can also help you look beyand the sensor, and to a board issue. Just seems like more troubelshooting is needed.

[davebtech]

Re: Sharp mx-m264

Did you do sim 30-1 before just ordering sensors. That may lead you to the sensor. It can also help you look beyand the sensor, and to a board issue. Just seems like more troubelshooting is needed.

Replaced dilivery unit no go Can anyone even manually fill this center tray anyway.held that center tray arm down and it does nothing on different 264.

[rapidocument]

Re: Sharp mx-m264

What about checking/changing the wiring to that sensor.

[Ratchet2501]

Re: Sharp mx-m264

Replaced dilivery unit no go Can anyone even manually fill this center tray anyway.held that center tray arm down and it does nothing on different 264.

You would have to hold that one in the up position to simulate something sticking out of the exit tray.

[davebtech]

Re: Sharp mx-m264

You would have to hold that one in the up position to simulate something sticking out of the exit tray.

This is the tray sensor that sits in the belly (center)of the machine where the paper lays AFTER exit .It lays in the up position and once a paper comes out it lays on top pushing the sensor down.There is no true exit sensor right after the final exit rollers on arm257, mxm 264.

[spotlifter]

Re: Sharp mx-m264

This is what he meant.
5.jpg

A happy Merry Very X mas to you all!!!!
And A New Newer Year!!!

[davebtech]

Re: Sharp mx-m264

This is what he meant.
[ATTACH=CONFIG]38477[/ATTACH]

A happy Merry Very X mas to you all!!!!
And A New Newer Year!!!

[davebtech]

Re: Sharp mx-m264

Does anyone have latest firmware update file for this Sharp mxm 264n? Thanks Dave

[moose55]

Re: Sharp mx-m264

Go to SIM 30-1. TFD1, 2 or 3 should show you which sensor is detecting paper full state.

[davebtech]

Re: Sharp mx-m264

Go to SIM 30-1. TFD1, 2 or 3 should show you which sensor is detecting paper full state.

Thanks but been there done that need to try firmware if anyone has?

[Ratchet2501]

Re: Sharp mx-m264

Apologies, I didn't even think to attach a diagram. *facedesk*

[davebtech]

Re: Sharp mx-m264

Apologies, I didn't even think to attach a diagram. *facedesk*