AR-M355, Maintenance Indicator...

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Oystercopy
    Senior Tech

    Site Contributor
    500+ Posts
    • Oct 2009
    • 579
    #1

    AR-M355, Maintenance Indicator...

    I am new to this machine, but I'm going in to replace the Developer and Drum Units. I need to know how to reset the "Maintenance Required" indicator on the panel, after I'm through. I assume, like most Sharps that there is no Developer calibration?
    thanks
    OC
    Tags: assume, developer, maintenance, panel
    • ZOOTECH
      Senior member of CRS

      Site Contributor
      2,500+ Posts
      • Jul 2007
      • 3381
      #2
      Re: AR-M355, Maintenance Indicator...

      Originally posted by Oystercopy
      I am new to this machine, but I'm going in to replace the Developer and Drum Units. I need to know how to reset the "Maintenance Required" indicator on the panel, after I'm through. I assume, like most Sharps that there is no Developer calibration?
      thanks
      OC
      To reset the maint counters, use SIM 24; DV calibration is with SIM 25-2.
      "You can't trust your eyes, if your mind is out of focus" --

        Comment

        • copiertec
          Service Manager

          Site Contributor
          1,000+ Posts
          • Jan 2016
          • 2172
          #3
          Re: AR-M355, Maintenance Indicator...

          Developer calibration 25-2, but leave the left door open after you change the developer and install developing unit. Enter sim 25-2 execute close door and wait for sim to finish, CA twice and you should be good to go. Sim 24 to clear counts. The reason to leave the door open is to prevent the MFP from adding unwanted toner before sim.

            Comment

            Previous template Next
            Working...