Looking for sharp mx-2600n transfer belt#1 assembly

[jper34]

Hi Folks,
looking for a new sharp MX-2600 transfer belt assem. "oem" DUNT-8062DS17,
Thanks..
Jaime
Indep. Copier Svc.
CT.

[dsmith46]

Re: Looking for sharp mx-2600n transfer belt#1 assembly

Here ya go:

Sharp MX-2600N 1st Transfer Belt Assembly, Genuine (M2406)

[paul.felton2]

Re: Looking for sharp mx-2600n transfer belt#1 assembly

Cheapest option is the PM kit

part no

MX-310U1

[ntbann]

Re: Looking for sharp mx-2600n transfer belt#1 assembly

Never had good luck rebuilding sharp transfer belts. Belt gets creased when trying to reassemble. They squeak. They streak. New primary belt unit is the way to go!

[guitar9199]

Re: Looking for sharp mx-2600n transfer belt#1 assembly

Never had good luck rebuilding sharp transfer belts. Belt gets creased when trying to reassemble. They squeak. They streak. New primary belt unit is the way to go!

I've never rebuilt a Sharp A3 transfer belt assy, but I've done a bunch of the A4 transfer belts on the MX-B402SC units.

[jp74msj55]

Re: Looking for sharp mx-2600n transfer belt#1 assembly

Never had good luck rebuilding sharp transfer belts. Belt gets creased when trying to reassemble. They squeak. They streak. New primary belt unit is the way to go!

If you buy from Sharp directly about $205.00

[schotschen]

Re: Looking for sharp mx-2600n transfer belt#1 assembly

Never had good luck rebuilding sharp transfer belts. Belt gets creased when trying to reassemble. They squeak. They streak. New primary belt unit is the way to go!

I have to say that I can not agree with that. I've reassembled a lot of these belts.
If you use the original Sharp kits with wiper blades and pay attention to enough Kynar powder and the cleaning of the rollers, there are no problems!
You can get Kynar powder under the number: UKOG-0123FCZZ

[fireater]

Re: Looking for sharp mx-2600n transfer belt#1 assembly

Hi Folks,
looking for a new sharp MX-2600 transfer belt assem. "oem" DUNT-8062DS17,
Thanks..
Jaime
Indep. Copier Svc.
CT.

the mx410 u1 are cheaper and work great in 2600's