Getting Poor Quality Color Prints on MX-4501N; B&w printing is ok

[Jrheinst]

Please see attached image. Colors are printing faded on MX-4501N. Also, the print feels gritty when it comes out of printer and some of it rubs off. This is not a problem with B&W printing. B&W prints and copies come out just fine.

[bilyahn]

Re: Getting Poor Quality Color Prints on MX-4501N; B&w printing is ok

Could be a lot of things. What have you done so far?

[igi]

Re: Getting Poor Quality Color Prints on MX-4501N; B&w printing is ok

Hi

Start by printing single color see which one is at fault.

That is your starting point.

Good luck.

[OlliK1969]

Re: Getting Poor Quality Color Prints on MX-4501N; B&w printing is ok

Hi

have you the right transfer-belt-unit in ?
Is the test print on the belt?

[mojorolla]

Re: Getting Poor Quality Color Prints on MX-4501N; B&w printing is ok

Gritty is usually too much developer in the mix. Run 25-1 for 10 seconds and see what the reading are for CMY. These older Sharp are known for developer clumping in high humidity settings.