Sharp MX-M753 replaced DSPF control board

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • dustzona
    replied
    Re: Sharp MX-M753 replaced DSPF control board

    Originally posted by JR2ALTA
    If you have a little patience they are not hard to make on your own. Cut a white sheet, roughly like this.
    Thanks , I'll try that

    Leave a comment:


  • dustzona
    replied
    Re: Sharp MX-M753 replaced DSPF control board

    Originally posted by mloudy
    I have a MX-M623N in the disposal area so I pulled the ADF board from it. It has 1846DS62 stamped on it. If you want it you can have it for the cost of shipping.

    We should also have a UKOG-0333FCZZ floating around that we will likely never use again.
    My email ( affix60@gmail.com ) send me an invoice . Thank you !

    Leave a comment:


  • JR2ALTA
    replied
    Re: Sharp MX-M753 replaced DSPF control board

    If you have a little patience they are not hard to make on your own. Cut a white sheet, roughly like this.
    Attached Files

    Leave a comment:


  • mloudy
    replied
    Re: Sharp MX-M753 replaced DSPF control board

    I have a MX-M623N in the disposal area so I pulled the ADF board from it. It has 1846DS62 stamped on it. If you want it you can have it for the cost of shipping.

    We should also have a UKOG-0333FCZZ floating around that we will likely never use again.

    Leave a comment:


  • dustzona
    started a topic Sharp MX-M753 replaced DSPF control board

    Sharp MX-M753 replaced DSPF control board

    I replaced a bad DSPF control on a MX-M753 with a board from another machine . It keeps giving a E6-11 code, if I'm remebering correctly. I probably need a shading adjustment sheet , part # UKOG-0333FCZZ . I dont have a source for that sheet ,so if someone has one to sell has a source for it that would help . thanks , also looking for a used control board CPWBX1846DS51 , 52 ,60
Working...