MX-m6070 lines

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • bilyahn
    replied
    Re: MX-m6070 lines

    Haven't had this on this particular series but when I have had 46-74 fail on previous series, I try to do a 67-24 first then go back and do the 46-74. Has worked for me when process control is screwed up and nothing else seems to work.

    Good luck.

    Bil

    Leave a comment:


  • JR2ALTA
    replied
    Re: MX-m6070 lines

    Does it just beep twice or something? that's not terribly uncommon on this devices. Sometimes putting a stack of white sheets behind the original works.

    But it's probably not wise to try 46-74 if the original is already messed up

    Leave a comment:


  • a.schott1191
    replied
    Re: MX-m6070 lines

    Originally posted by JR2ALTA
    Sounds like your process control is out of whack. After clearing 24 drum and MC counts..Have you run 44-2, 44-27, 44-6, 44-26? Then try 46-74.
    Yes I did, all of those completed successfully. Fails at 46-74, first scan from the glass.

    Sent from my Pixel 6a using Tapatalk

    Leave a comment:


  • JR2ALTA
    replied
    Re: MX-m6070 lines

    Originally posted by a.schott1191
    Hello, I have an MX-m6070 that is leaving lines on prints. The type of lines that are caused by lack of charge on the charge corona in certain areas. The lines bounce around from print to print. The full Halftone test prints look like crap, the density is dark and light in different areas. I plugged in a new Main Charge, Drum, cleaning blade - No dice. It's like I'm not getting charge in random parts, so my drum is 'more positive' in random places.
    Also SIM46-74 fails, probably because the gradation is so bad.

    Any ideas?

    Sent from my Pixel 6a using Tapatalk
    Sounds like your process control is out of whack. After clearing 24 drum and MC counts..Have you run 44-2, 44-27, 44-6, 44-26? Then try 46-74.

    Leave a comment:


  • a.schott1191
    started a topic MX-m6070 lines

    MX-m6070 lines

    Hello, I have an MX-m6070 that is leaving lines on prints. The type of lines that are caused by lack of charge on the charge corona in certain areas. The lines bounce around from print to print. The full Halftone test prints look like crap, the density is dark and light in different areas. I plugged in a new Main Charge, Drum, cleaning blade - No dice. It's like I'm not getting charge in random parts, so my drum is 'more positive' in random places.
    Also SIM46-74 fails, probably because the gradation is so bad.

    Any ideas?

    Sent from my Pixel 6a using Tapatalk
Working...