Have a machine, that has taken a elect, hit.was on a surge protector,didnt help.Machine was dead.Repl. mother PWB,PCU,PWB,Roms on MFP,then lastly MFP.up and running now machine warms up, and just says please wait?Any ideas.Tryed replacing, scanner cable to MFP PWB, and scanner PWB. no changed?
-
-
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads
Paul@justmanuals.com
-
Did you replace the hard drive as well? Also if it was on a Sharp surge protector aren't they guaranteed to protect your machine or it is replaced?
Good luck.
BilComment
-
I didn't the the power supply in your list of "installed PWB's". =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Try replacing or switching the PCU and Control PWB flash roms with the old ones.
These models tend to hang up when Boards had been replaced.
Good luck.Comment
-
Sorry yes power supply was repl. too.Comment
-
Ah yes swapped Pcu and roms around from different machines and the old ones?Comment
-
I have not repl. HHD?And it was on a surge but it was also in a 100 year old mill.So you know!Comment
-
Right..The HDD could also be another cause..Comment
-
Update!Swapped Feeders out worked fine.Put the old feeder back on still says please wait.Changed out feeder harness,Feeder PWD on feeder?So help!!!!! i have to fix this feeder?Sensors?2 side scanner?Comment
-
It's probably the scan PWB, but beware! The metal plate below the scan PWB is close enough that if you press upward it will short out the solder joints on the bottom of the board. Whenever I have to remove the scan board I tape a transparency to the metal to act as an insulation layer. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
Comment