MX-FN11 Finisher

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • otuvak
    Trusted Tech

    100+ Posts
    • Aug 2010
    • 102

    #1

    MX-FN11 Finisher

    Looking for part numer for the staple cartridge(The part you load the staples into). Looked through service manual and parts manual. Thanks for any help!
  • bonnie750
    Trusted Tech

    250+ Posts
    • Nov 2007
    • 302

    #2
    Re: MX-FN11 Finisher

    They will be listed here,by copier not finisherListing SHARP COPIER STAPLES ,if not they will tell you which host you need

    Bill

    Comment

    • bilyahn
      Service Manager

      1,000+ Posts
      • Dec 2006
      • 1470

      #3
      Re: MX-FN11 Finisher

      Here you go. But it shows up as an invalid part number on Sharp even though I got this from one of their TT. All that I could find for now.

      Good luck.

      Bil

      0JPCRT530C-S


      Comment

      • igi
        Service Manager

        1,000+ Posts
        • Apr 2009
        • 1507

        #4
        Re: MX-FN11 Finisher

        h all
        as far as i know sharp parts
        it must be 13-entries
        you got 12 on yours
        good luck

        Comment

        • bilyahn
          Service Manager

          1,000+ Posts
          • Dec 2006
          • 1470

          #5
          Re: MX-FN11 Finisher

          Originally posted by igi
          h all
          as far as i know sharp parts
          it must be 13-entries
          you got 12 on yours
          good luck
          Very true. Normally 5 letters, 4 numbers, then a mix of 4 letters or numbers, although there are other combinations. I have seen part numbers as long as 15 characters though.

          Comment

          • bonnie750
            Trusted Tech

            250+ Posts
            • Nov 2007
            • 302

            #6
            Re: MX-FN11 Finisher

            Hey Bilyahn

            The number is correct except it has a / at the end. 0JPCRT530C-S/

            regards

            Bill

            Comment

            • otuvak
              Trusted Tech

              100+ Posts
              • Aug 2010
              • 102

              #7
              Re: MX-FN11 Finisher

              Thanks everyone!

              Comment

              Working...