mx2310u

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Akitu
    replied
    Re: mx2310u

    Originally posted by dibyendu
    Thanks friends, the said problem solved after replacing the MFP CONTROLLER PWB.. Thanks again for your replies.
    Thanks for the response, but for the sake of curiosity, was the SD card replaced/reseated prior to the MFP Control PWB?

    Leave a comment:


  • dibyendu
    replied
    Thanks friends, the said problem solved after replacing the MFP CONTROLLER PWB.. Thanks again for your replies.

    Leave a comment:


  • leogets
    replied
    Re: mx2310u

    Confirm the status of the LED (red) below the CPU heat sink on the MFPC PCB
    If the LED is ON the SD card is probably faulty
    Once you replace the SD card you will need to force firmware upgrade


    lee

    Leave a comment:


  • JustManuals
    replied
    Re: mx2310u

    This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


    Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


    Paul@justmanuals.com

    Leave a comment:


  • Akitu
    replied
    Re: mx2310u

    I've heard that reseating the SD card may resolve this error, I haven't tested it myself personally though.

    Leave a comment:


  • sharphead
    replied
    Re: mx2310u

    Always annoying when its a new machine.

    Try disconnecting finisher/ extra trays if there are any installed you could also tray the firmware upgrade from dead method

    Leave a comment:


  • dibyendu
    started a topic [Dead] mx2310u

    mx2310u

    Hello friends.
    I have a problem in one new mx2310u machine. After installation 3 month it working fine. Now the problem is when power is given to the machine no display is glowing. Control panels small led is flowing and fan is rotating . Heater lamp and scanner not glowing. I have cleaned ram and Rom in mfp controller pwb but still machine is dead. I have already cross check scanner controller pwb, dc power supply and pcu pwb. Plz help me to out of the problem. Customer is very annoyed..
Working...