If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Does anyone know the proceedure to turn off the error message when no network cable is connected to the MXM363N series?
I've heard that if you un-check the "Enable TCP/IP" box in Network Settings, it will shut down the error message. On the older machines you could set TC 66-1 soft switch 103, bit 8 to a one.
"You can't trust your eyes, if your mind is out of focus"--
Comment