Reset the developer Icon in the display of a AR M162? I've searched and there is no DV calibration. Where is the DV reset? Not under any of the 20's codes I can find. Reset PM didn't help. WTF?
Roy
Roy
-
-
Re: How in the world do I....
You're correct, sir. There is no stir, but you can reset the developer message in 20-01. =^..^=
Correction: Damn, you're right, it's 42-01. CRSLast edited by blackcat4866; 09-27-2013, 02:06 AM.If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Re: How in the world do I....
This machine was set up like the old Sharp's where DV counter clear is at sim 42-1Comment
Comment