Sharp simulation mode

[fuser101]

Re: Sharp simulation mode

44-14 will show temperature and humidity reading both internal and external.

Right, but am I able to access 44-14 while the copier is running a long run in order to monitor the high and low temp fluctuations?
When I enter in to 44 as the copier is running it stops the copy run at that point so then when I get sub mode 14 all i can do is see what the temp is at in stand-by.
I do appreciate all of the suggestions and help.
thanks,

[mojorolla]

Re: Sharp simulation mode

44-14 will show temperature and humidity reading both internal and external.

[fuser101]

Re: Sharp simulation mode

I am trying to verify the operating temp of the fusing unit in order to evaluate some bearings and AM rollers that I have been sampled.

thanks for your help,

[igi]

Re: Sharp simulation mode

I need to monitor the temperature while the copier is running.
thanks,

why whats happening to your machine

[igi]

Re: Sharp simulation mode

Thanks for your help it is appreciated. I just quickly reviewed sim-7 in the SM will I be able to monitor the temp of the fuser or just the warm-up time?


thanks again

just warm-up
you can change the temperature with sim-43,but you cannot measure.

[fuser101]

Re: Sharp simulation mode

Thanks for your help it is appreciated. I just quickly reviewed sim-7 in the SM will I be able to monitor the temp of the fuser or just the warm-up time?

thanks again

[igi]

Re: Sharp simulation mode

yes aging test
sim-7

[fuser101]

New to Sharp model MX-M503
Is it possible to be in simulation mode and run copies at the same time?
I have been told this is not possible.
I do have a service manual but have yet to look in to this myself.
Many other OEMS have this ability. I need to monitor the temperature while the copier is running.
thanks,