Copies are moving on test prints, but machine is not jamming. Sometimes the first copy out is dead on in the middle, but after that all copies are six inches off. See attachment pic. Thanks in Advance.
LCB Test Print.jpg
LCB Test Print.jpg
-
-
Re: e-studio 202L
The rubber pads on the paper/tray feed solenoids may have deteriorated. You may need to replace the rubber pads. The rubber on the solenoid actuator becomes sticky with age and holds the paper feed solenoid open.
Make sure you clean the old pad off completely, and maker sure replace it with a similar pad with the same thickness.
HTHInauguration to the "AI cancel-culture" fraternity 1997...
•••••• •••[§]• |N | € | o | M | Δ | t | π | ¡ | x | •[§]••• •••••• -
Re: e-studio 202L
This model uses magnetic clutches and if they were slipping the machine would record a jam. Thanks for your post, I welcome all answers.Comment
-
Re: e-studio 202L
I thought 202 where similar to the ES205...
How old is the machine ? Is it in a dirty dusty environment ?
Try cleaning the mag-clutchs and shafts. If the clutchs are binding the same thing will happen.Inauguration to the "AI cancel-culture" fraternity 1997...
•••••• •••[§]• |N | € | o | M | Δ | t | π | ¡ | x | •[§]••• ••••••Comment
-
Re: e-studio 202L
This is a dinosaur. It was released in 2006. They were fairly well built, and we have dozens of them still under contract. It uses magnetic clutches that do not disassemble. It's fairly common for the set screw to back out of the registration clutch so it spins free, and that might account for your registration issues.
Toshiba E STUDIO 202L Toner Cartridges
=^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: e-studio 202L
I checked the two set screws on the registration clutch and they were good and tight. I put it back together and it started working, but not for long. Went out today and cleaned the registration photo sensor and the 1st transport photo sensor and now it seems to be working correctly. Thanks for everyone's input.Comment
Comment