-
-
Re: Toshiba e-studio 5540 again...
You likely have a charge/bias leakage issue (developer, main charge, transfer) that is causing the backgrounding and stripping developer material out of the dev tank (the stripping in the cyan colour suggests it is also losing dev material).
I would go through all of the main charge assemblies for each drum and disassemble and clean them as thoroughly as you can, replace any grids that look suspect (in a pinch you can clean them with acetone if they are not too badly corroded).
There was also a common issue with this series where the end terminal block on each TR1 roller inside the transfer belt assembly would crack causing either leakage of current or causing the TR1 roller to get stuck in the down position.No, I will not send you Manuals, Software or your own little repair Genie to fix all your problems for you.
-
Re: Toshiba e-studio 5540 again...
I find it curious that you're condemning the machine, when you've used generic supplies. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
Comment