F105 on E3511
Collapse
X
-
Hard drive and firmware reload are required. The sector check will pass and this will come back. If the drive is a maxtor it will not pass a sector check when hot... -
SH manual says :
(1) Check if the connectors of the HDD are disconnected.
(2) Check if the connector pins are disconnected or the wires of harnesses are open circuited.
(3) Perform the bad sector check (08-694). If the check result is OK, recover the data in the HDD. If
the check result is failed, replace the HDD.
(4) Replace the SYS board.Leave a comment:
-
Leave a comment: