e-studio 16

[acetler]

i need error code c38
when turn on machine "broken registration"
when i press *,1,3 keys write c38
what is that code?

[djzolla]

hey chap,

i believe that error points to the process unit. replace it

regards

[copyguy5]

TOSHIBA eSTUDIO 16 Service Manual

I could not locate the code but you may find the Service Manual helpful. You can download from:

http://www.copierprofessionals.com/protectedmembers/201519/eS16/ES16P_SERV_PTS.pdf

Good Luck

COPYGUY5

[Mr Spock]

C38 Replaced process unit error

The broken registration sometimes corrupts the nvram and when "repaired" it checks the cartridge to see if it is new. Try 08-689-1 then 08-673 start.

[museumfriends]

studio e 160 "broken registration"

hi everyone,

i too have the same problem - after overriding the system yesterday with *13 to get past the passwords, this morning i couldn't use the new department code passwords i had set on copier.

i used *13 again to try and go through and reset all passwords, and now i have 'broken registration'.... this doesn't sound good!?

i am viewing a previous post about this from acetler, and the link to the copierprofessionals pdf is broken...

help!!

i don't think there are any problems (unless i have caused them) because the copier worked fine yesterday when we overrode the codes.

HELP!!!