Estudio 351c Toner Caliberation

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • rukshan4u2c
    Technician
    • Mar 2011
    • 49

    #1

    Estudio 351c Toner Caliberation

    Estudio 351c Toner Caliberation
    Hi ...
    Can you please advise me how to disable the toner caliberation once the powering up is done. It takes few seconds to complete the caliberation process to make use of the machine.
    Is there a way of knocking down this process or if its been stopped will it be harmful at the long run???

  • JustManuals
    Field Supervisor

    5,000+ Posts
    • Jan 2006
    • 9838

    #2
    This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
    Just Manuals | The Internet's largest selection of manuals | Instant Downloads


    Paul@justmanuals.com

    Comment

    • emujo
      Field Supervisor

      2,500+ Posts
      • Jun 2009
      • 3009

      #3
      I would only disable the color cal if you are troubleshooting a color problem. Emujo
      If you don't see your question answered in the forum, please don't think it's OK to PM me for a personal reply...I do not give out firmware and/or manuals.

      Comment

      • michaelc
        Field Tech

        Site Contributor
        500+ Posts
        • Mar 2011
        • 590

        #4
        When the machine starts up its does a check of the toner density, cleans the charger corona wire, IQC (density) as well as other things. I don't fully understand what you mean by toner calibration, I'm guessing its the IQC density check. If you disable this CQ will get worse over time.
        When you say 'powering up', do you mean from energy save or from the machine being turned off for a length of time?
        It didn't say that I couldn't do it in the manual.

        Comment

        • rukshan4u2c
          Technician
          • Mar 2011
          • 49

          #5
          Hi Mic..
          Well basically machine starts up after the energy saving mode it takes time for toner calibration. well if its not good for the machine better to leave it as it is..thanks brother

          Comment

          Working...