3500c c3a0

[digicor]

ok i have another toshiba issue... 3500c throwing a c3a0 code, magenta atdc sensor.. ive changed it and still get the code, ive re set the 08-574 thru o and still codes, do these machines have inherant pc board problems?? it only has 111k on it!!!

[Hansen88]

Re: 3500c c3a0

I hane not seen many board problems at all with that model. But I do see a lot is that the developer mixlevel in the units depletes to the point of getting codes like you have and others too. Usually just install new mix in that unit and run the developer code in the 05 mode and that usually takes care of it.

[digicor]

Re: 3500c c3a0

thanks for the insight, the manual always goes from something that might make sense then right to the board, with no other suggestions or solve's.
thanks again.

[emujo]

Re: 3500c c3a0

That's because Toshiba doesn't want to list in their trouble shooting guide "check developer level in IU due to possible design flaws". It should be the #1 check point for almost all CQ issues on this MFP. Emujo

[digicor]

Re: 3500c c3a0

hahahahaha thats a laugh! i see that would be admitting this machne is a POS?(piece of sh)
chuckle chuckle chuckle.... im doing a dv change right now, man can they charge me more? i paid 430.00 for the stuff, precision was a week out from getting any and the rest of my vendors dont "do" toshiba color... now i know why....not even any on e bay.... now i kow why...
LOL

[emujo]

Re: 3500c c3a0

430.00? not too bad, we were paying close to 600 for the color pm kits. I think gold is less expensive per ounce. Emujo

[digicor]

Re: 3500c c3a0

i concur
chuckle chuckle