If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I just replaced charger wire and grids on EPU unit. Now the cyan density is low. I reiniatialized the auto toner sensors and ran a gamma adjustment. No change. I'm also looking for a saddlesticth tray for MJ-1020 finisher. Can anyone help?
Last edited by mpact; 04-02-2008, 03:48 AM.
Reason: Additional request
Low Density on Toshiba 310c