our friends, please helps me, i have a toshiba copier e-255, sometimes miss feeding from cassette1, i replaced the registration sensors but no response finally, replaced the registration clutch. the paper always miss feed at A4-R, when A4 the drawered paper not straight one edge higher than the other edge(the front and trialling edge not straight). what are the problem?
-
-
Re: Jamming at e-255
Hi!
While we wait for a qualified Toshiba tech to show up, let us get some of the basics out of the way.
What is the condition of the feed unit components? Specifically, if that machine has a separation roller, are there any flat spots on it? (If you hold the separation roller up to the light, any lines you see on the roller indicate flat spots,which will cause intermittent misfeeds.)
Next, Make sure that the machine understands you are feeding the size of paper that is loaded in that drawer. If there are paper size sensors or a dial or lever that needs to be set so that the machine recognizes the paper size, make sure they are clean and set properly.
And finally, and probably the least useful because you most likely have done this already, take all the paper out of that drawer and make sure that there isn't a few sheets at the bottom of the stack that have a corner folded under.
Well, that is all I've got. Hopefully a Toshiba tech will show up and give you more help soon. Still, good luck!
Comment