F106 e350 help

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Steve0
    A+, MCP, MCSE
    • Jan 2008
    • 13
    #1

    F106 e350 help

    hi every body

    i have a e350 machine, today it don't run and appear F106 code.

    Intravia book say “point and print partition problem”, but i don’t know how to do.. help me please.

    thanks for all help me out of a difficulty.
    Tags: e350, f106, off, usb
    • nilsonmorales
      #2
      i have the manual

      i dont know but have the service manual just send me a email nilsonmorales@hotmail.com

        Comment

        • Mr Spock
          Vulcan Inventor of Death

          1,000+ Posts
          • Aug 2006
          • 2064
          #3
          08-690-2 start will reformat the hard drive.
          If it continues (or is a maxtor harddrive) then replace the drive and reload the firmware.
          And Star Trek was just a tv show...yeah right!

            Comment

            • decimal
              Technician

              50+ Posts
              • Aug 2006
              • 75
              #4
              i had same problem but i can't reformat harddisk because mode 08 doesn't work , it display "WAIT" forever .When i reload firmware(i use USB) it does display number 0 (OS update) .What happen??

                Comment

                • Sbarro
                  Trusted Tech

                  100+ Posts
                  • Feb 2008
                  • 176
                  #5
                  You have to read firmware update guide
                  In eBridge 1 machine (like 350/450) you have to load on pen
                  first only the XXX.rom file and load in "49" mode on the machine.
                  After OS update don't turn it off ,take out pen ,put rest of the files on it and stick it on machine USB port again and push START.
                  After succesfull update remember to initialize firmware (08-947)
                  "A process cannot be understood by stopping it. Understanding must move with the flow of the process, must join it and flow with it"

                  "                  What do you despise? By this you are truly known"

                  Guess who

                    Comment

                    • Steve0
                      A+, MCP, MCSE
                      • Jan 2008
                      • 13
                      #6
                      Thanks Mr. Spock,

                      It was maxtor, so I replaced hard drive.
                      It is working now.

                      Thak you all,

                        Comment

                        • decimal
                          Technician

                          50+ Posts
                          • Aug 2006
                          • 75
                          #7
                          Hi Sbarro
                          I see .But even there is only ROM.bin on USB it also does display number 0 .I updated 1-6(HDD,UI.SYS.scan..) ok and only this SYS board was.
                          The other sys boards have been updated normaly .I know this SYS board has problem,i hope someone has exp. about it

                            Comment

                            Previous template Next
                            Working...