Toshiba E-455 RADF late paper eject

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • gideon
    Trusted Tech

    Site Contributor
    250+ Posts
    • Dec 2009
    • 283

    #1

    Toshiba E-455 RADF late paper eject

    When the paper exit sometime it doesn't eject all the way to the exit tray it will cause either for disorder in the paper sequence or worst fold them and jam. I tried to adjust the exit roller press springs, didn't help, looks like the exit motor doesn't run long enough, did you have to replace to solve this problem, can't find in the manual time setting for this motor, any idea? Thanks.
  • Gregg

    #2
    Re: Toshiba E-455 RADF late paper eject

    Light oil on all the bushings(check out for wear) usually clears this up. Gets gummy.

    Comment

    • gideon
      Trusted Tech

      Site Contributor
      250+ Posts
      • Dec 2009
      • 283

      #3
      Re: Toshiba E-455 RADF late paper eject

      Thanks, clean the bushings and it works.

      Comment

      • canonbundy
        Senior Tech

        500+ Posts
        • Jun 2012
        • 607

        #4
        Re: Toshiba E-455 RADF late paper eject

        Can't remember if this model uses an MR3018 RADF if so check the Exit Diverter Flapper for breakage on the plastic actuator from the solenoid - this will cause pages out of sync, folding & jams.

        Comment

        Working...