Charge

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • noid
    Junior Member
    • Nov 2012
    • 5

    #1

    Charge

    Do the e-studio midrange copiers use charge wires or direct contact charge rollers?
  • sagar4
    Trusted Tech
    • Dec 2012
    • 127

    #2
    Re: Charge

    Originally posted by noid
    Do the e-studio midrange copiers use charge wires or direct contact charge rollers?
    They seem to be all going to transfer rollers for the mid size series. Still using corona wires for the higher volume copiers. Hope this helps.
    "Broken again"

    Comment

    • noid
      Junior Member
      • Nov 2012
      • 5

      #3
      Re: Charge

      Originally posted by sagar4
      They seem to be all going to transfer rollers for the mid size series. Still using corona wires for the higher volume copiers. Hope this helps.
      Thanks, but do they use corona wires to charge the drums on the mid size?

      Comment

      • arnh79
        Trusted Tech

        Site Contributor
        VIP Subscriber
        250+ Posts
        • Apr 2010
        • 467

        #4
        Re: Charge

        No, they use needle electrodes.
        Why does every customer think they're the first one to ever say: "you've been here so much we should get you an office, ha, ha, ha"?

        Comment

        • nmfaxman
          Service Manager

          Site Contributor
          1,000+ Posts
          • Feb 2008
          • 1702

          #5
          Re: Charge

          Pull it out and look at it.
          Why do they call it common sense?

          If it were common, wouldn't everyone have it?

          Comment

          • michaelc
            Field Tech

            Site Contributor
            500+ Posts
            • Mar 2011
            • 590

            #6
            Re: Charge

            Might be easier if you listed the models you are enquiring about. Would be able to give a better answer.
            It didn't say that I couldn't do it in the manual.

            Comment

            Working...