e studio 255 tray 1 over driving/grinding

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • MRCOPY
    Junior Member
    • Jan 2009
    • 6
    #1

    [Misc] e studio 255 tray 1 over driving/grinding

    Paper in tray 1 continues to lift after contacting feed rolls. Didn't leave grinding continue (no error code). Should I replace complete feed assembly, or just paper sensor. Has anyone else ran across this?



    Thanks in Advance
    Tags: 255, grinding noise, toshiba
    • sagar4
      Trusted Tech
      • Dec 2012
      • 127
      #2
      Re: e studio 255 tray 1 over driving/grinding

      I have the same issue on a few machines. Normally its just the sensor but I had to replace a couple of feed assemblies for the same issue. I would just replace the whole feed to be on the safe side.
      "Broken again"

        Comment

        • MRCOPY
          Junior Member
          • Jan 2009
          • 6
          #3
          Re: e studio 255 tray 1 over driving/grinding

          OK, Thanks
          I will get the feed assembly.

            Comment

            Previous template Next
            Working...