e-166 not geting ready ( "0" keep on blinking), I tried with another mother and power board, but the problem not solved. I tested the fuser unit but it working fine. what could be the problem help to find.
-
-
Re: Not getting ready
Try resetting the nvram. Start the copier with the keys *13 pressed. It should make a long beep. I know you said you tried with another motherboard, but i had this kind of issue before and this kind of reset helped. -
Re: Not getting ready
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.comComment
-
Re: Not getting ready
Punch the display panel, if it still works then you have not hit it hard enough. It may work as a fix but if it does not you feel better.It didn't say that I couldn't do it in the manual.Comment
Comment