Toshiba ES 455 buckling paper

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Kidaver
    Ghoulscout

    500+ Posts
    • Apr 2011
    • 912

    #1

    Toshiba ES 455 buckling paper

    I have a ES 455 with an LCF that is buckling the paper about 5 cm from the leading edge. It only does it when pulling from the LCF and the buckle is pretty consistent along the page. Is there an adjustment or maybe an issue I'm not seeing I should be looking for?
    "In a cruel and evil world, being cynical can allow you to get some entertainment out of it."
  • vincent64
    Trusted Tech

    250+ Posts
    • Feb 2008
    • 382

    #2
    Re: Toshiba ES 455 buckling paper

    If you have not already changed the reg. clutch on the rear, try that, there is also a tech pub about some adjustments on buckle from the trays...

    Comment

    • Kidaver
      Ghoulscout

      500+ Posts
      • Apr 2011
      • 912

      #3
      Re: Toshiba ES 455 buckling paper

      ok I'll take a look at the reg clutch....I'm more a Konica Minolta and Kyocera tech but we picked up a few Toshibas in a contract...I have the manuals and such and was searching thru them but they don't mention the LCF much in them so I'm guessing it has it's own manual....I don't have access to the tech pub but I might know someone who can help me with that hopefully....thanx for the info...
      "In a cruel and evil world, being cynical can allow you to get some entertainment out of it."

      Comment

      • Toshitec
        MFP Engineer
        • May 2011
        • 22

        #4
        Re: Toshiba ES 455 buckling paper

        For this problem I can say, try to downsize the drive-up time from the LCF.
        Start up with 0-5, choose code 457 and take steps of +/- 5 down from the original number.
        You can try this until the buckle shape is gone.
        Succes almost guaranteed !

        Comment

        • canonbundy
          Senior Tech

          500+ Posts
          • Jun 2012
          • 607

          #5
          Re: Toshiba ES 455 buckling paper

          Originally posted by Kidaver
          I have a ES 455 with an LCF that is buckling the paper about 5 cm from the leading edge. It only does it when pulling from the LCF and the buckle is pretty consistent along the page. Is there an adjustment or maybe an issue I'm not seeing I should be looking for?
          Does the Unit Jam when the symptoms described are displayed?

          Before adjusting or time consuming replacing - produce an Error List > 9+Start > Power On > 107 Start then > 103 will give a PM Report.
          If a Code E190 is evident (this indicates the Paper has not left the LCF), then clean/replace the Seperation Roller or replace the Roll Kit.

          Comment

          • Alex1
            Trusted Tech

            Site Contributor
            250+ Posts
            • Oct 2012
            • 285

            #6
            Re: Toshiba ES 455 buckling paper

            Originally posted by Kidaver
            I have a ES 455 with an LCF that is buckling the paper about 5 cm from the leading edge. It only does it when pulling from the LCF and the buckle is pretty consistent along the page. Is there an adjustment or maybe an issue I'm not seeing I should be looking for?
            Ive done several Clutches on these machines there a common problem, I replace them on the pick up feed or rego rollers

            Comment

            Working...