Toshiba e-Studio 2100c Fiery problem
Hi,
My problem is that the Fiery isn't booting up anymore; after about 5 minutes after the machine is turned on, the Fiery won't pass the "System booting, please wait..." message, or just "Please wait...".
When I enter the Config Mode on the machine, Installation, the Parallel Port flushes, I hit ok for copying the files, the message "installation in progress..." comes on for about 5 seconds, and then "Installation failed. Timed out (4)".
Have you ever experienced something like that? I think I have to reinstall the linux operating system on the fiery through the parallel port but I don't know if it is possible.
In the following post, the problem is the same on a Canon printer but I cannot find the equivalent of the CANON PDL DOWNLOADER for TOSHIBA :
Thanks a lot.
My problem is that the Fiery isn't booting up anymore; after about 5 minutes after the machine is turned on, the Fiery won't pass the "System booting, please wait..." message, or just "Please wait...".
When I enter the Config Mode on the machine, Installation, the Parallel Port flushes, I hit ok for copying the files, the message "installation in progress..." comes on for about 5 seconds, and then "Installation failed. Timed out (4)".
Have you ever experienced something like that? I think I have to reinstall the linux operating system on the fiery through the parallel port but I don't know if it is possible.
In the following post, the problem is the same on a Canon printer but I cannot find the equivalent of the CANON PDL DOWNLOADER for TOSHIBA :
Thanks a lot.