Wait message during copying

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • JVC
    Trusted Tech

    100+ Posts
    • Jun 2011
    • 151

    #1

    Wait message during copying

    Hello

    I have an es4520c that keeps pausing during large copy jobs. If I run a 50 copy job it will pause about every 10 copies or so. I have seen simular problems and either the machine is low on toner or replacing the thermopiles is the issue. I have checked both with no change. Has anyone seen this and have suggestions?

    Thank you
  • arnh79
    Trusted Tech

    Site Contributor
    VIP Subscriber
    250+ Posts
    • Apr 2010
    • 468

    #2
    Re: Wait message during copying

    Are any of the process units past PM? I've seen that series keep trying to add toner to compensate for low developer levels.
    Why does every customer think they're the first one to ever say: "you've been here so much we should get you an office, ha, ha, ha"?

    Comment

    • Hansen88
      Service Manager

      Site Contributor
      1,000+ Posts
      • Dec 2009
      • 1066

      #3
      Re: Wait message during copying

      I have had the thermopiles just be dirty causing problem like that ,even though they looked ok. I just swabbed them with a q tip and problem went away.

      Comment

      • Hansen88
        Service Manager

        Site Contributor
        1,000+ Posts
        • Dec 2009
        • 1066

        #4
        Re: Wait message during copying

        Also once i had one lamp that was burned out with no kind of codes. Machine was slow to heat and need to wait in middle of runs.

        Comment

        • JVC
          Trusted Tech

          100+ Posts
          • Jun 2011
          • 151

          #5
          Re: Wait message during copying

          Thank you for the answers. I cleaned them and it seems to be working. I ran 100 copier straight before I could not get 10 out.

          Comment

          Working...