If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Check that gate solenoid is not binding on the linkage pin. Also check the mylar guides on the plastic guide plate. I have also had ribs get worn to the point of snagging the lead edge.
Anyone seen duplex inverter jams on this model? Paper stops in inverter, rollers not driving. Not a connection issue, duplex works on different machine. Can not run inverter motor from output mode, thinking of IOB board.
Last edited by Bicyclerepairman; 05-19-2015, 04:53 AM.
Reason: want to make it a question
Leave a comment: