If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Getting partial image when scanning on flatbed and adf. Internal prints Ok. I'm leaning towards scanner ribbon cable or controller. Anyone have this before. Thx T
Getting partial image when scanning on flatbed and adf. Internal prints Ok. I'm leaning towards scanner ribbon cable or controller. Anyone have this before. Thx T
Hi My Friend
You need to check one of the mirror in optics(care fully) out of position not cables
Comment