[Dead] Installazione SW imposibile

[brubru]

[Phil B.]

Re: Installazione SW imposibile

IN ENGLISH!

[adriansto]

Re: Installazione SW imposibile

Deactivate Windows XP firewell and reinstall software again.

[SeniorTch]

Re: Installazione SW imposibile

IN ENGLISH!

Impermissible SW installation

I found the xerox DC250 whose rip EFI was not ready; The scan icon on All services of the display did not light up so I tried to reinstall the SW of the snatch without succeeding because During the procedure the loading of the Second Show the system IS BLOCK failed
I tried a Change more CD of Installation POI a change in sequence Hard Disk then Feeder of the rip without result
What can I do ????
ps I might think to exceed the SIMM RAM of the RIP (what kind is ???)

[SeniorTch]

Re: Installazione SW imposibile

[brubru]

Re: Installazione SW imposibile

Impossible to Install SW on RIP Fiery Embedded
I found the Xerox DC250 where RIP EFI was not ready; The icon scan on all the services of the display was not lit so I tried to reinstall the SW of the RIP without fail because during the procedure to load the second present the system crashes failed I tried a change more Install CD then a change in the Hard drive sequence then rip feeder without result I can do????
PS I could think of overcoming the RAM Simm of the RIP (what type is???)

[brubru]

Re: Installazione SW imposibile

Impossible to Install SW on Fiery RIP Embedded
I found the Xerox DC250 where RIP EFI was not ready; The icon scan on all the services of the display was not lit so I tried to reinstall the SW of the RIP without fail because during the procedure to load the second present the system crashes failed I tried a change more Install CD then a change in the Hard drive sequence then rip feeder without result I can do????
PS I could think of overcoming the RAM Simm of the RIP (what type is???)

[brubru]

Re: Installazione SW imposibile

Impossibie to install SW on Fiery RIP EmbeddedI found the Xerox DC250 where RIP EFI was not ready; The icon scan on all the services of the display was not lit so I tried to reinstall the SW of the RIP without fail because during the procedure to load the second present the system crashes failed I tried a change more Install CD then a change in the Hard drive sequence then rip feeder without result I can do????
PS I could think of overcoming the RAM Simm of the RIP (what type is???)

[adriansto]

Re: Installazione SW imposibile

What version of Fiery software did you tried to install ?
Post here photo with the white label ( located on top of the Fiery cage ) with 3 serial numbers printed on it.

[almerico]

Re: Installazione SW imposibile

Usa il cavo cross. Ho avuto lo stesso problema durante l'installazione, si bloccava ad un terzo del secondo steep. Che sistema fiery devi installare?